TEGERE BUILDERS LIMITED

Fiber cement board kenya supplier

Raw Materials:Cement,Quartz Sand,Fiber and Other non hazardous ingredients.
easy to install and paint, can be nail or screw on timbe or steel studs.
Nornal size   1220*2440      4feet*8feet  thickness ranging from 3.5mm to 30mm

Fiber cement board application:

-3.5-6mm for interior ceiling and can be used for the facing panel of Sandwich Board

-8-15mm for the interior partition

-8-12mm for the External Siding, Cladding or Facade

-18-22mm for the furniture desk

-18-30mm for Indoor Floor Decking

-22-30mm for Indoor Stair

Fire resistant:   

Non-Flammability: Grade A

Weather resistant:

Resistant to Deformation in Wet, Hot and Dry Conditions.

 Water-resistant:

The board still keeps Intact after being Soaked in Water for One Month ,the Phenomenon of Swelling and Out of Shape will Not Happen.

 Bug & Mildew free:

Non-Nutrient to Mold ,Fungus Growth or Insect Life.

 Insulation:

 Superior Sound Insulation Factor of a Wall built from the fiber cement board and aslo a superior Heat Insulator.

 Environmentally Friendly:

NOT contain any Toxic ingredients ,Asbestos Formaldehyde or Ammonia.

Fiber cement board installation

 Tools: 

No special tools are required. The products can be used with normal nails, fastened by normal or self-drilling screws and cut by an electric power saw with a diamond blade.

Fixing: 

Fiber cement board can be fixed to both timber (minimum size 1.5 x 3 inches) or steel frames (at least 0.55 mm thickness). The board must be supported at the edge at intermediate positions with centers not exceeding 600 mm. Screws must be located more than 12 mm from edges and 50 mm from board corners.

Fastener: 

Fasteners can be both nails and screws. It can be nailed directly to timber supports with round wire nails. For metal screws, the size and length of the screw depends on the thickness of the board and the gauge of framing. Pre-drilling the board is a must unless self-embedding, self-drilling head screws.

Jointing: 

Since fibre-cement board is subject to slight dimensional changes, a butt joint can be used in dry partitioning areas or where an exposed joint appearance is acceptable. For better water protection, either flexible acrylic or polyurethane based sealant can be used to seal gaps of 3-5mm.